Pertronix Electronic Conversion Kits
Click
Here For Prices
Click
Here For Testimonials
Click
Here For Installation Instructions
4
Cyl. Delco
This kit will
only fit 4 cylinder Delco distributors.
Notice on the
distributor cap p/n 393-9459 ( old # 33667 ) that there are 2 screws which go thru the cap
to hold it down and 2 more screws underneath the cap which hold the electronic
plate assembly down to the distributor.
This kit does not
include the distributor cap.
This
is the Magnetic sending ring which is included. This ring must be pushed down to
the second set of the 4 flats or the rotor will not set low enough. Before
installing this ring, measure the distance from the top of your distributor
shaft down to the 4 lobes on the shaft and make note. Slide this ring on until
you feel the first 4 flats engage. Now push it down further until it bottoms out
on the 2nd set of flats. The distance now from the top of the distributor shaft
down to the top of the magnetic ring will be .030 shorter. This will let the
rotor to set low enough to clear the top of the distributor cap. It will only be
a total of .030 higher than it was before installing the conversion kit.
Sorry,
there are no returns on electrical items.
: Order # 1146

V-6
Prestolite Screw Down Cap
For V-6
distributors with points and a Prestolite screw down cap.
Sorry,
there are no returns on electrical items.
: Order # 5293


V-8 Mallory
This kit will
most 305 & 350 Chevy engines made until 1982 with Mallory distributors.
Notice on the
distributor cap p/n 391-5075 that there are 2 notches for 2 lever arms which
tilt upward and have 2 small screws on top for clamping down the distributor
cap.
This kit does not
include the distributor cap.
Sorry,
there are no returns on electrical items.
: Order # 2520

V-8 Ford Engines
MerCruiser uses 4
different distributors in the Ford engines.
Please compare
your distributor caps with the ones we have shown here and above ( Mallory )

Click
Here For Prices